A fully updated 2021 JN0-681 Exam Dumps exam guide from training expert BraindumpsVCE Provides complete coverage of every objective on exam and exam preparation JN0-681 NEW QUESTION 26 Your manager asks you to secure ARP and DHCP traffic across your local Ethernet links.In this scenario, which technology will accomplish this task? A. SSL B. MACsec C. a firewall filter D. IPsec Answer: B NEW QUESTION [...]

A fully updated 2021 JN0-681 Exam Dumps exam guide from training expert BraindumpsVCE [Q26-Q43]

Share

A fully updated 2021 JN0-681 Exam Dumps exam guide from training expert BraindumpsVCE

Provides complete coverage of every objective on exam and exam preparation JN0-681

NEW QUESTION 26
Your manager asks you to secure ARP and DHCP traffic across your local Ethernet links.
In this scenario, which technology will accomplish this task?

  • A. SSL
  • B. MACsec
  • C. a firewall filter
  • D. IPsec

Answer: B

 

NEW QUESTION 27
An EVPN-signaled VXLAN overlay has been deployed in the network shown in the exhibit. Host1 is a bare metal server, and is dual-homed to the network. The IP addresses 10.1.1.1/24 and 10.1.1.2/24 are assigned to the same physical NIC, and no virtualization is configured on the server.

In this scenario, which two statements are true? (Choose two.)

  • A. Traffic from IP address 10.1.1.1/24 must traverse the VXLAN network to reach IP address 10.1.1.2/24
  • B. The connection host1 to devices leaf1 and leaf2 must be configuration a LAG.
  • C. The MAC address associated with 10.1.1.1/24 and 10.1.1.2/24 will be same when advertised to leaf3.
  • D. The ESI assigned to the host1 link must be the as the ESI assigned to the leaf2 host1 link.

Answer: B,D

 

NEW QUESTION 28
Which two statements describe MAC address learning for VPLS and EVPN? (Choose two.)

  • A. EVPN learns MAC addresses in the data plane
  • B. EPLS learns MAC addresses in the control plane
  • C. EVPN learns MAC addresses in the control plane
  • D. VPLS learns MAC addresses in the data plane

Answer: C,D

 

NEW QUESTION 29
You want to configure redundant Layer 3 gateways.
In this scenario, which two Juniper best practices would accomplish this task? (Choose two.)

  • A. configuring both IRB interfaces manually with the same MAC address.
  • B. allowing Junos to dynamically create the virtual MAC address of the IRB interface.
  • C. allowing Junos to dynamically create the virtual IP address of the IRB interface.
  • D. configuring both IRB interfaces manually with the same IP address.

Answer: B,D

 

NEW QUESTION 30

Referring to the exhibit, VMs on Server-1 are sending traffic to VMs on Server-2. All VCPs in the VCF have 40Gbps of bandwidth available and automatic fabric trunking is bundling multiple VCPs together.
Which statement is correct in this scenario?

  • A. The traffic will load balance across the SW-1, SW-2, and SW-3 devices.
  • B. The traffic will load balance across the SW-1 and SW-2 devices.
  • C. The traffic only takes the SW-4, SW-2, SW-5 path.
  • D. The traffic only takes the SW-4. SW-1, SW-5 path.

Answer: A

 

NEW QUESTION 31
Referring to the exhibit, DC1 and DC2 have a DCI across a service provider WAN connection. Host1 in DC1 must have Layer 2 connectivity to host2 in DC2. A VXLAN tunnel must be created between VTEP1 and VTEP2.

In this scenario, which statement is true?

  • A. The service provider WAN connection be an MPL5-based WAN connection.
  • B. A route to the loopback address on VTEP must be present on VTEP1.
  • C. VXLAN Layer 3 gateway must be provisioned at the Super Spine layer.
  • D. VTEP and VTEP2 must peer using IBGP.

Answer: B

 

NEW QUESTION 32
You are asked to configure VXLAN for you c data center using multicast to exchange VTEP information?
In this scenario, which two configuration parameters must match on the VTEPs in the same VXLAN segment? (Choose two.)

  • A. VLAN ID
  • B. Routing instance name
  • C. VNI
  • D. Multicast group

Answer: C,D

 

NEW QUESTION 33
What is the purpose of the command shown in the exhibit?

  • A. to disable the multicast group 239.0.0.1 across the entire VXLAN.
  • B. to stop the reception of transit multicast traffic when there are no interested receivers attached to the local VTEP.
  • C. to disallow IGMP requests for the group 239.0.0.1 from hosts attached to the local VTEP.
  • D. to stop the transmission of transit multicast traffic when there are no interested receivers attached to a remote VTEP.

Answer: D

 

NEW QUESTION 34
Referring to the exhibit, Host 1 and Host 3 have exchanged traffic.

`
In this scenario, which statement is true?

  • A. Leaf 2 learn Host 1's MAC address when Host 3 learns Host 1's MAC address.
  • B. Leaf 2 learn Host 1's MAC address when Leaf 1 queries Host 1.
  • C. Leaf 2 learn Host 1's MAC address through periodic updates from Spine 2
  • D. Leaf 2 does not learn Host 1's MAC address until Host1 and Host2 send traffic to each other

Answer: A

 

NEW QUESTION 35
A client with five data centers spread around the country uses MPLS L2VPNs to provide point-to-point data center Interconnects between each data center in a full-mesh network. The client is considering an MPLS EVPN implementation.
In this scenario, what are three advantages of using MPLS EVPN interconnects? (Choose three.)

  • A. They provide for lower transmission latency.
  • B. They provide for a local proxy ARP/ND resolution.
  • C. They provide for point-to-multipoint connectivity.
  • D. They provide for static configuration that does not require a Dynamic Routing Protocol.
  • E. They provide for MAC learning in the control plane.

Answer: B,C,E

 

NEW QUESTION 36
Host1 and host2 are connected to an EVPN signaled VXLAN overlay, and must have Layer 3 connectivity.
The VNI and VLAN assignments are shown in the exhibit.

In this scenario, which two statements are true? (Choose two.)

  • A. A layer 3 gateway can be configured on the spine devices.
  • B. The VNI assigned to the host1 link must be same as the VNI assigned to the host2 link.
  • C. A Layer 3 gateway can be configured on the leaf devices.
  • D. The ESI assigned to the host1 link will be different from the ESI assigned to the host link.

Answer: A,C

 

NEW QUESTION 37
The MC-LAG group shown in the exhibit is providing high availability services for the directly connected servers.

Where does Juniper Networks recommend you provide the backup liveness detection?

  • A. on the ae1 interface
  • B. on the management interfaces
  • C. on the ae2 interface
  • D. on the ICL-PL connection

Answer: D

 

NEW QUESTION 38
Which two statements are true about Virtual Chassis? (Choose two.)

  • A. By default, Junos switches are in a non-mixed mode Virtual Chassis.
  • B. The request virtual-chassis mode fabric reboot command will set the Virtual Chassis to mixed mode.
  • C. By default, Junos switches are in mixed mode Virtual Chassis.
  • D. The request virtual-chassis mode fabric reboot command will set the Virtual Chassis to fabric mode with similar devices.

Answer: A,B

 

NEW QUESTION 39
The MC-LAG group shown in the exhibit is providing high availability services for the directly connected servers. The backup liveness detection is applied to the ICL-PL link, however, when one of the members rebooted, there was traffic loss for a few seconds.

In this scenario, where should you apply the backup liveness detection?

  • A. on the management interfaces
  • B. on the ae1 interface
  • C. on the ae0 interface
  • D. on the ae2 interface

Answer: A

 

NEW QUESTION 40
The MC-LAG group shown in the exhibit is providing high availability services for the directly connected servers. The backup liveness detection is applied to the ICL-PL link, however, when one of the members rebooted, there was traffic loss for a few seconds.

In this scenario, where should you apply the backup liveness detection?

  • A. On the management interfaces
  • B. On the ae0 interface
  • C. On the ae2 interface
  • D. On the ae1 interface

Answer: A

 

NEW QUESTION 41
Which EVPN router type prevents BUM traffic from looping back to a multihued host?

  • A. Ethernet segment router
  • B. IP prefix route
  • C. Inclusive multicast-Ethernet tag route
  • D. Ether auto discovery route

Answer: D

 

NEW QUESTION 42
Your colleague has begun working on the base configuration for an active-active multihomed EVPN connection shown in the exhibit.

Which two actions will ensure a successful implementation? (Choose two.)

  • A. Change the ESI mode on PE1 to signal-active
  • B. Change the ESI value on the PE1 device to 00.22.44.88.00.22.44.66.88
  • C. Change the ESI value on the PE2 device to 00.00.00.00.00.00.00.00.00.00
  • D. Change the ESI mode on PE2 to all-active

Answer: B,D

 

NEW QUESTION 43
......

Tested Material Used To JN0-681: https://www.braindumpsvce.com/JN0-681_exam-dumps-torrent.html